Whether it is an Eichler in Balboa Highlands or a conventional tract home, a new AC is only as good as the installation behind it. We size every Granada Hills system with a real load calculation, not a square footage guess, and back the work with our installation warranty.
Repairing an aging system is not always the wrong call, but sometimes a new install is the smarter financial decision. These are the clearest signs it is time to stop repairing and start planning a replacement.
Most residential AC systems are built to last 12 to 15 years. Past that mark, efficiency drops and the odds of a major component failure rise sharply, even with regular maintenance.
If you have called for repairs more than twice in the last two summers, or a single repair quote is approaching half the cost of a new system, replacement usually saves money over time.
An aging or undersized system loses efficiency gradually. If your cooling bills have crept up without a change in habits, the system is likely working harder than it should to do the same job.
R-22 was phased out of production in 2020. If your system still uses it, refrigerant for a leak repair is expensive and getting harder to source, and replacement is often the more practical route.
Some rooms cold, others warm, no matter the thermostat setting, often means the system was undersized or poorly matched to the home from the start, not just a maintenance issue.
A system that short cycles or runs nearly nonstop is either the wrong size for the home or losing efficiency fast. Either way, a proper load calculation on a new install usually resolves it for good.
Granada Hills sits nearly 1,000 feet above sea level, one of the higher points in the Valley, and a 1949 community newspaper even credited that elevation with making the area unusually smog-free and frost-free. A system sized off a generic Valley-floor chart is often the wrong fit here, so we run a full Manual J load calculation for every installation built around the property's actual elevation and exposure, not a rule of thumb.
Construction type matters just as much here. The 108 Eichler homes of Balboa Highlands, built in the 1960s with open post-and-beam construction and floor-to-ceiling glass, need a completely different sizing approach than a conventional stucco tract home nearby. We evaluate the property's actual construction on every installation so a new system is not sized off a one-size-fits-all assumption, and we plan for equipment placement during the initial site visit, not after it is already on order.
We measure the home, inspect existing ductwork, and run a Manual J calculation to determine the correct tonnage for your specific property.
You get a clear, itemized quote showing the equipment, SEER rating, and total cost before anything is ordered.
Old equipment is removed, new line sets are brazed, and the system is installed to manufacturer and code specifications, typically in a single day.
We verify refrigerant charge with digital gauges, test airflow at every vent, and walk you through the new thermostat before we leave.
Final pricing depends on tonnage, SEER rating, and your home's specific ductwork condition. These are typical ranges for a full installation in Granada Hills.
| System Type | Typical Range |
|---|---|
| 2 to 2.5 ton, standard SEER2 | $5,500 – $8,500 |
| 3 to 3.5 ton, standard SEER2 | $6,500 – $9,500 |
| 4 to 5 ton, standard SEER2 | $8,000 – $12,000 |
| High-efficiency upgrade (18+ SEER2) | Add $1,500 – $4,000 |
| New or replacement ductwork | $2,000 – $6,000 |
TOP CLUB members and financing options are available. Every quote is written and itemized before any work begins.
Free load calculation, written itemized quote, and financing options available.
Tell us what’s happening and our certified technicians will contact you shortly.
Before you go — share a few quick details and we'll reach out with your free quote.
Tell us what’s happening and our certified technicians will contact you shortly.
