With so much of Reseda built out in the same compressed early-1950s boom, an install that ignores whether your home has its original ductwork or a later remodel is a system sized for guesswork. We size every Reseda system with a real load calculation, not a square footage guess, and back the work with our installation warranty.
Repairing an aging system is not always the wrong call, but sometimes a new install is the smarter financial decision. These are the clearest signs it is time to stop repairing and start planning a replacement.
Most residential AC systems are built to last 12 to 15 years. Past that mark, efficiency drops and the odds of a major component failure rise sharply, even with regular maintenance.
If you have called for repairs more than twice in the last two summers, or a single repair quote is approaching half the cost of a new system, replacement usually saves money over time.
An aging or undersized system loses efficiency gradually. If your cooling bills have crept up without a change in habits, the system is likely working harder than it should to do the same job.
R-22 was phased out of production in 2020. If your system still uses it, refrigerant for a leak repair is expensive and getting harder to source, and replacement is often the more practical route.
Some rooms cold, others warm, no matter the thermostat setting, often means the system was undersized or poorly matched to the home from the start, not just a maintenance issue.
A system that short cycles or runs nearly nonstop is either the wrong size for the home or losing efficiency fast. Either way, a proper load calculation on a new install usually resolves it for good.
Reseda's population grew 185 percent between 1950 and 1953 alone, as large ranches and orange groves were subdivided into postwar tract housing almost overnight. That compressed timeline means an unusually large share of homes here share the same construction era and floor plan, but original ductwork condition still varies home to home depending on whether it was ever replaced or upgraded since. We run a full Manual J load calculation for every installation rather than assuming every 1950s tract home is identical.
Reseda was also the actual epicenter of the 1994 earthquake that history remembers as the Northridge quake, centered near Wilbur Avenue and Saticoy Street. Homes closest to that epicenter took the most direct structural stress, and we check for foundation or duct-seal issues tied to that history as part of every installation, not just standard age and condition.
We measure the home, inspect existing ductwork, and run a Manual J calculation to determine the correct tonnage for your specific property.
You get a clear, itemized quote showing the equipment, SEER rating, and total cost before anything is ordered.
Old equipment is removed, new line sets are brazed, and the system is installed to manufacturer and code specifications, typically in a single day.
We verify refrigerant charge with digital gauges, test airflow at every vent, and walk you through the new thermostat before we leave.
Final pricing depends on tonnage, SEER rating, and your home's specific ductwork condition. These are typical ranges for a full installation in Reseda.
| System Type | Typical Range |
|---|---|
| 2 to 2.5 ton, standard SEER2 | $5,500 – $8,500 |
| 3 to 3.5 ton, standard SEER2 | $6,500 – $9,500 |
| 4 to 5 ton, standard SEER2 | $8,000 – $12,000 |
| High-efficiency upgrade (18+ SEER2) | Add $1,500 – $4,000 |
| New or replacement ductwork | $2,000 – $6,000 |
TOP CLUB members and financing options are available. Every quote is written and itemized before any work begins.
Free load calculation, written itemized quote, and financing options available.
Tell us what’s happening and our certified technicians will contact you shortly.
Before you go — share a few quick details and we'll reach out with your free quote.
Tell us what’s happening and our certified technicians will contact you shortly.
