A heat pump replaces your AC and your furnace with one system, moving heat instead of burning fuel to make it. We size every heat pump for your specific Canoga Park home with a real load calculation and back the installation with a written warranty.
A heat pump is not a different kind of AC. It is one system that both cools and heats your home by moving heat instead of burning fuel to create it. Here is what makes it worth considering.
If your AC and furnace are both approaching the end of their life around the same time, replacing both with one heat pump is often more cost effective than replacing each separately.
Because a heat pump moves existing heat rather than generating it from fuel, it can run at 300 to 500 percent efficiency, far above a gas furnace's maximum of around 98 percent.
One system means one annual tune-up and one set of parts to maintain, instead of coordinating separate service for an AC and a furnace on different schedules.
Heat pumps often qualify for utility and manufacturer rebates that a standard AC or furnace replacement does not, given their role in reducing overall energy use.
Some older Canoga Park homes, especially those built during the neighborhood's post-war boom, were built with cooling only, or with wall heaters as the sole heat source. A heat pump adds proper central heating without installing a separate furnace.
Modern inverter-driven heat pumps run at variable speeds rather than cycling fully on and off, which typically means quieter operation and steadier indoor temperatures.
Heat pump performance is rated two ways, not one. SEER2 measures cooling efficiency, the same rating used on a standard AC, while HSPF2 measures heating efficiency, a number a straight AC system does not have at all. Standard heat pumps start losing heating capacity as outdoor temperatures drop below the mid-20s, but Canoga Park's winter lows typically sit in the mid-40s, well within the range where a properly sized heat pump performs at full efficiency without needing backup heat.
That matters for sizing decisions specific to this area. A heat pump chosen only for its cooling capacity, the way an AC-only system might be sized, can be a poor match for actual winter performance if the HSPF2 rating was not factored in from the start. We size every Canoga Park heat pump installation for both numbers together, accounting for the home's insulation, ductwork condition, and typical winter lows, not just the summer heat this area is more commonly known for.
We run a Manual J calculation for both cooling and heating demand, since a heat pump has to be sized correctly for both seasons, not just summer.
You get a clear, itemized quote showing both efficiency ratings and total cost, so you know exactly what you are buying before anything is ordered.
Old equipment is removed, new line sets are brazed, and the heat pump is installed to manufacturer and code specifications, typically in a single day.
We verify refrigerant charge, test both heating and cooling modes, and walk you through the new thermostat and its heat pump settings before we leave.
Final pricing depends on tonnage, SEER2 and HSPF2 ratings, and your home's existing ductwork. These are typical ranges for a full heat pump installation in Canoga Park.
| System Type | Typical Range |
|---|---|
| 2 to 2.5 ton, standard efficiency | $7,000 – $10,500 |
| 3 to 3.5 ton, standard efficiency | $8,500 – $12,500 |
| 4 to 5 ton, standard efficiency | $10,500 – $15,000 |
| High-efficiency upgrade (18+ SEER2 / 9+ HSPF2) | Add $2,000 – $5,000 |
| Ductless mini-split system (per zone) | $3,500 – $6,500 |
TOP CLUB members, financing, and available rebates can lower these numbers further. Every quote is written and itemized before any work begins.
Free load calculation, written itemized quote, and financing and rebate options available.
Tell us what’s happening and our certified technicians will contact you shortly.
Before you go — share a few quick details and we'll reach out with your free quote.
Tell us what’s happening and our certified technicians will contact you shortly.
